A set of products usually have several or more than ten parts. The main matching dimensions of these parts are guaranteed by computer gong processing. It is very important to choose a reasonable tolerance, especially some product design drawings do not consider the matching problem. Bottom, surface, shell fit, shape is no doubt 0 to 0 fit, positioning is guaranteed by the mouth, concave mouth and convex mouth tolerance is generally 0.1 mm, unilateral. The fit on the big body is like a transparent mirror. The shape of the general accessories is 0.1 ~ 0.2 smaller than the size on the big body. The shape of the movable accessories on the big body, such as buttons, is 0.1 ~ 0.5 smaller than the shape on the big body. The surface shape of the accessories on the big body is generally consistent with the surface shape on the big body, which can be removed from the big body.
1、 Exit angle (draft angle)
All plastic molds should have a mold angle, otherwise they will be scratched. If it is not indicated in the drawing, you can discuss with the mold maker. The mold angle is generally 0.5 ~ 3 degrees. If the mold is etched, the mold angle should be larger, 2 ~ 5 degrees, depending on the thickness of the etched pattern.
2、 Cutting problem
Most of the time, when the cutter is just milled, the amount of cutting is relatively large, which is easy to cause the cutter to break and bounce. At this time, you can first roughen the lower cutter position, or lift the cutter away, or lower the cutter outside the material in the daytime. In a word, this problem should be fully considered. Grab the knife, spring the knife, drop the knife, when the processing capacity is relatively large, the knife clip is too long, the knife is too small, this often happens. When the processing capacity is relatively large, especially when the concentration feed is large, it is easy to occur. For example, when the depth of the smooth side is 50 mm and the diameter is 3 / 4, we can process it in 25 mm twice, so it is not easy to occur. Tool clamping is too long, the length of the tool is very important for processing, should try to clamp short, beginners are easy to ignore this problem, the program paper must indicate the length of the tool clamping. It’s easy to grab the knife when turning the corner. The solution is to use a smaller knife to clear the corner layer by layer, and then change the larger knife to smooth the side.
3、 Sharpen a knife
The shapes of computer gongs are different, so we often need to grind all kinds of knives. When all kinds of molding knives are worn out, we also need to grind them. Only when we reach the following points can we grind a usable knife.
- The four corners of the tool should be the same height.
- A is higher than D.
- The forward (tool face) of the tool is higher than the back, that is, it has a certain back angle.
4、 Milling direction
The reason is that the rigidity of the computer gong is relatively good, it is not easy to let the cutter, the back clearance is small, and the milling shape or inner groove is left compensation. When machining left and right symmetrical shapes, the profile tool path cannot be mirrored, otherwise the processing effect of the mirrored side is not good. In order to communicate with the operator of the machine tool, the program paper should include:
- Program name
- Tool size and length
- Method of machining tool path
- Machining allowance
- Rough or light knife
- Drawing file name 4
About the author