1. Before machining in each program, it is necessary to strictly confirm whether the tool is consistent with the program.
2. When installing the tool, it is necessary to confirm whether the length of the tool and the selected tool holder are suitable.
3. It is forbidden to open the door when the machine tool is running to avoid flying knife or workpiece.
4. In case of knife collision during the processing of computer gongs, the operator must stop immediately, such as pressing the “emergency stop” button or “reset key” button or setting the “feed rate” to zero.
5. In the same workpiece, each tool setting should be kept in the same area, so as to ensure the accuracy of the tool when connecting the tool, and the operation rules of CNC machining center.
6. If too much machining allowance is found in the machining process, the “single section” or “pause” must be used to clear the X, y, Z values, and then manually mill them off, and then swing back to the “zero” to let them run by themselves.
7. During self operation, the operator shall not leave the machine tool or regularly check the operation status of the machine tool. If it is necessary to leave midway, relevant personnel must be designated to check.
8. Clean the aluminum slag in the machine tool before the smooth knife oil injection to prevent the aluminum slag from absorbing oil.
9. Try to blow with air in the rough opening procedure and spray oil in the light knife program.
10. After the workpiece is off the machine, the burr must be removed in time.
11. When off duty, operators must make timely and accurate handover to ensure the normal follow-up processing.
12. Before shutdown, make sure that the tool magazine is in the original position and the XYZ axis is in the middle position. Turn off the power supply and the general power supply on the operation panel of the machine tool in turn.
13. In case of thunderstorm, the power supply must be cut off immediately.
In addition to the above points, there are many things that we need to pay attention to from time to time. The system should pay attention to, and the machine should also pay attention to maintenance. In fact, most of the time, the machine will break down, to a large extent, and the user’s operation is improper. We do not pay attention to check the machine before starting up, and do not warm up. Some companies have long been in the dark and humid environment because of the bad environment In fact, if we deal with these problems in time, the service life of our machine will definitely be much longer. The machining accuracy and performance of the machine will be as new as before, and the loss will be greatly reduced, and the replacement frequency of parts and components will be greatly reduced It saves a lot of time and cost
If there is any abnormal phenomenon in the operation process, please contact the manufacturer in time to avoid unnecessary loss.
About the author