After the workpiece is placed on the pad iron, it is necessary to pull the table for the workpiece datum according to the drawing requirements. For the workpiece that has been ground on six sides, it is necessary to check whether its verticality is qualified.
The nut must be tightened after the work-piece is pulled to prevent the work-piece from shifting during the processing due to the loose clamping; pull the work-piece again to ensure that the error does not exceed the tolerance after the clamping.
Number of workpieces touched
For the clamped workpiece, the contact head can be used to set the processing reference zero position. The contact head can be used in photoelectric type and mechanical type. There are two kinds of methods: middle collision number and unilateral collision number
Photoelectric static, mechanical speed 450 ~ 600rpm. Manually move the x-axis of the worktable according to the collision number to make the collision number head touch one side of the workpiece. When the collision number head just touches the workpiece and the red light is on, set the relative coordinate value of this point to zero. Then manually move the x-axis of the worktable to make the collision number head touch the other side of the workpiece. When the collision number head just touches the workpiece, record the relative coordinate at this time.
According to the relative value minus the diameter of the collision head (i.e. the length of the workpiece), check whether the length of the workpiece meets the requirements of the drawing.
About the author