Multi chip saw is a tool for wood processing, and the requirement for this tool is relatively high. There is also the existence of a single saw, the function of which is the same as the multiple saw, but it can only be used for simple wood processing, so it can only be used in more difficult wood processing. And the demand for single saw is relatively low, because its role is relatively small, so in general, poor quality single saw can also be used.
But the requirement for multichip tools is high, because the main purpose of using them is to save materials and improve efficiency. Because the multi saw is made up of many saw blades, the surface of these saw blades must be smooth, otherwise it will be difficult to use. In addition, saw blades should be thinner, because too thick saws may not work well, and they will take up the place.
This tool is also very convenient and quick to work. First, put wood at its feed inlet and then wait for it to come out at the discharge port. Its efficiency is very high. * it can produce twenty to thirty square lumber, which is not available by other equipment.
Multiple saw has a variety of advantages, which is the main reason people are willing to use it, and our ordinary life can not be separated from it, its role is very important.
Multi saw is a combination of multiple saw blades, and a single saw is a single saw operation. The general requirement for a single operation is not very high, even if the quality is slightly worse. But the multiple saw is not the same, and the requirements of the saw blade are higher, but the use of multiple saws generally requires a comparison of wood saving and sawing. Small, the saw blade is very good.
Customized multi model square lumber sawing saws factory direct sale
First of all, we talk about the problem of the card machine. The card machine is usually caused by the improper operation of the workers. After the timber is cut down from the forest farm, it is ready to go through the branch and then pass the cutting to the multi saw. The nature of the wood determines its processing difficulty, the scar on the wood, the harder place, the workers if they have the Scars are always in the direction of the sawtooth, because the lateral hardness of the wood is uneven, and if the quality of the saw blade is not good, at this time the transverse sawblade can not unanimously cut the wood, it will produce uneven force and can easily be stuck to wood. Good multi saws generally use better quality saw blades, even if the hard scars can be very longitudinal, and will not encounter the problem caused by the uneven force of the saw blade. Again, the problem of wood sawing saw blade, generally burning saw blade after the equipment factory, manufacturers in the selection of multiple saw, do not pay attention to the quality of the problem, burning saw blade generally because in the sawing wood, heat radiation does not cause heat concentration in time. In order to avoid such a situation, the general multi saw will have a cooling device. The saw blade material used in good multi chip saws is conducive to heat dissipation, and there are cooling holes on the saw blades. The general multi chip saw will test its quality before the factory is out of factory. Consult the manufacturer when changing the saw blade. The surface of the processed wood is not flat, and there are many reasons for this situation: the wear of the saw blade will cause this situation, the spindle is loosened because of the problem of use, and the surface of the jacket of the saw blade is not smooth, and the problem will be produced without attention when changing the saw blade. Generally speaking, although many saw saw the technical requirements of the workers are not high, but the workers still have certain requirements, and the machine will be used by the people who will use it.
About the author